In my case, I see CONFIG_USB_MON=y as the response… This means it’s built directly into the kernel instead of as a module.If not you have to either enable the kernel configuration rebuilt the kernel or need to build the usbmon as a kernel module. If you have built the usbmon.ko as the kernel module ,you can load it asĬheck whether usbmon, has loaded properly:Īlso make sure debufs is mounted. Grep CONFIG_USB_MON /boot/config-`uname -r` To check whether your kernel was compiled with USBMON support by checking the kernel config file for your product or by running: To dump USB traffic on Linux, the usbmon module is needed.ĭepending on the Linux distribution and its version, this module might be built into the kernel, or might be a loadable module. For setting up the installations and performing capture,you have to be running as root user.Īs the first step, plug in the USB device, then you need to have the following utilities setup and to be fully functional. The following sections describe this approach of capturing the usb transactions you need to get the following tools/libraries in your embedded linux system.

In many scenarios the product developers will need to understand the low level traffic happening on the USB physical bus to verify the protocol /data exchange sequence and thorughput of data transfer.

With the need of growing “digital device connectivity” ,usb is seen as cost effective ,relatively high performance bandwidth technology to interconnect devices for control and data transfers USB allows data to be transferred between devices. USB stands for Universal Serial Bus, an industry standard for short-distance digital data communications.

Usb traffic sniffer